Separate names with a comma.
I prefer the Vishay / BC Components PR02 metal film resistors for plates, grids, and at the input jack. They are rated at 2watts but are the same...
I built a 36watt 6V6 version of a Marshall 2203, and no bragging but the tone was really great, one of my best builds in tone really, sold it to a...
I'm not sure if this would work on a Pentode, but interesting reading .
Amp Parts Direct carries a lot of Heyboer iron, and most of it is made to ClassicTone spec. They used to be one of the two vendors that carried...
If you are building less than a 50 watt amp, I can highly recommend Musical Power Supplies for iron. I swear by their OT's. Some of their earlier...
Are you coming off of the + side of the secondary for the NFB, meaning the leg without the ground reference (like a Champ 5F1) ?
I have zero...
I use the Vishay / ERO MKT caps, like those that are being carried now at ValveStorm. They are great as far as being transparent (Transparent...
APD sources from Heyboer
I would be suspicious of any amp repair tech that says the OT is bad and now the amp is done for.
On a side note, I'm a big no fan of Weber OT's...
Your request is an easy enough, and isn't hard to do. That idea has been done a lot. So, yes we can, no sweat.
It's better to think of a 12AX7 as what it really is, and that is two equal triodes in one glass envelope. They are not really to be thought of as...
Yes, That printed PCB board is also made by Headfirst, which the end user populates. David filled this board.
I think that this amp is wired, but will have to look again once more with fresh eyes before slapping the power to it. Loads of pics below:...
Worked on the pot side, need to finish the input jacks, remote bias, and FX
Bolted in the board and have most of the socket side done.
'][img]Got the wires added, and have one more slight tidy up on flux. Rear photo for Gene as requested
Yeah, Ken thought purple wire was great.
My wife's niece used to live in Port St Lucie, but she moved out of state
PCB board is populated, have to add the wires to it then it's ready to bolt in. Need to also clean a few flux splatters too, I'm obviously not a...
Got a parts order in. Finished mounting the preamp sockets and heater wiring. Finished the power section, and selector switch