Search Results

Among mini pedals giving the effects that you want, I've got good or decent results with... -a Valeton CH10, "Loft" series chorus. More than...

Hi, My archived data about a bridge Invader mention a very high inductance (8.4 Henry) and a slightly higher Q factor than with a SH4, for...

What, this topic is still going on? :) I've nothing personal to add regarding MY use of MFX's but as a side note, I've found the following link...

Behringer pedals are fine but they host mediocre buffers IME. So, I wouldn't plug in a chain of Behringer's. One single pedal for a defined effect...

A Fuzz Face clone with low hfe transistors and a series resistor limiting the input of the circuit, IME...

I'm not El Gringo but Pat. Number's were wound on butyrate bobbins: this material would melt in boiling wax - and it smells like vomit when...

Awe, désolé compatriote, I was actually talking about a V1.2. :) I sympathize with your tinkering: the only OCD still in my possession is a home...

For those who'd want to try: a 2,2nF instead of the first coupling cap did set the low-mids bump to my liking in a V2 OCD. Of course and as...

As mentioned by some fellow member(s) above, a typical Marshall tone stack with all controls maxed out still scoops the mids: the notch frequency...

The tails passed through a chorus: https://www.mixonline.com/recording/classic-tracks-chris-isaaks-wicked-game-365028 I use modulated delays for...

OK. Personally, I'll keep using my 4CM rig with a digital MFX and the six other pedalboards (including two fully analog boards) that I've at...

+1. And to think out loud: it reminds me that analog dry thru is not rare, nor necessarily expensive. A Nux Tape Core Deluxe has it, for 60...

Thx for the link. In the past, I've done extensive experiments and measurements about capacitive loads. On this basis, I'd say that to my ears,...

Hi, For serious analysis, I plug the cumbersome lab gear used where I work but frankly, any good calibrated soundcard + a software like Rightmark...

I use digital MFX's in 4CM with tube amps since the late 90's and it works for me. Granted, it's not always easy to set. I typically use a...

Thx for the news! Regarding the Hum Destroyer: Behringer can be hit or miss IME... I'll try some day to check if the Behringer Hum Destroyer...

What about a HBE Detox between guitar and preamp? See here, after 0:32: [MEDIA] Or, for a comparable result, a parametric EQ also plugged between...

Hi again, The "pop" seems inherent to the switching network in your amp. The fact that it becomes a "thump" with the HX stomp made me think...

Hello, I've already dealt with loud switching noises actually due to imperfect grounding... And 4CM can generate problems of grounding and...

Interestingly, JBE humbuckers rely largely on the same recipe than the L500's or SH13 mentioned in my previous post: no cover, no brass or nickel...