Separate names with a comma.
Thanks but I'm not using eyelets for a few reasons. Turrets only.
I'm having trouble understanding this. So you need a block of wood with like... a hole drilled into it for the die to sit in?
I don't want to buy a drill press. No space/room for it in my apartment. So I was gonna go the pre-drilled route and then try to either press-fit...
...without a drill press? For turrets, do you prefer drilling and then press-fit, swage, or pre-drilled board and staking?
Noise: EMF, RF, crosstalk, ground hum/loops Phase cancellation Inductance
I say go for it. Why not. But... 10-12 awg is pretty thick lol. I use 14awg twisted pair I get in bulk. 30 feet of 14 AWG dual-conductor Van...
Hakko
Nothing wrong with current production Wimas.
The "problem" is there. You just aren't hearing it. But it definitely robs the amp of "mojo" lol. Any energy the amp puts into reproducing noise...
What "problem" are you referring to not having? Why does the gauge of the wire matter? There's a reason you brought it up I presume.
It's less than optimal layout/lead dress and creates ground loops. For a stock Marshall, fine. But once the gain starts going up and/or we deal...
It doesn't hurt as long as you aren't also grounding the preamp or pot lugs to that bus.
I don't like it. I prefer to run a bus bar through the actual lugs that require ground and then flying leads from the preamp to this bus bar. You...
Are you trying to do a Jose-style diode clipping mod?
Teflon RG-188 A/U from Apex Jr.
Sand the spot that needs soldering. Cut the already tinned portion of wire off. Even if it's just like an inch or something and start with fresh...
Why? Because it sounds good. And it sounds different than power section distortion and at much lower volumes. If you wanna play classic rock, then...
While a resistor's max working voltage is more of a derived/calculated spec based on how much heat the part can withstand, i.e. wattage rating...
I don't pull them straight. I use a non-serrated jewelers pliers with a wide mouth and press the leads between their jaws until straight.
I settled on a Benchmark DAC and HPA4 amp. I like Benchmark's no BS and anti-mojo stance. As far as those $27 resistors go, that's quite...
