Separate names with a comma.
Got the new tank and I have reverb! I thought this would be easy as all I have to do is get the polarity right, right? Well here's a handy tip if...
The "Life" of a tube is not what I look for. A tube can last 25 or even 50 years...I've proved that! But the thing is tone. I've swapped out 12...
Thanks!!! I went to schematic and it doesn't list the part; it just says "Reverb" where the tank is.
Thanks for the reply. The trouble has spread to both channels, so I have the pan unplugged and the amp works fine. The fact I get reverb along...
80mv is too high IMHO. On my DSL 50 I've gone as low as 32 and as high as the factory 45. For the past many years I've settled on 36, which would...
50 mv is WAY too high. The sweet spot is 32-36 on these amps. I would exchange the tubes for another pair. Ken
Yeah, I've been scare. It's not the tubes. And now I get feedback in the red channel also. When I unplug the tank, the amp works perfectly. BTW I...
DSL 50's don't have bias drift as a rule because they don't get as hot as the 100's. I've never had bias drift on mine and if it were a car it...
I'm getting occasional feedback even with the guitar and reverb volume on 0 on the green channel (not the red) that disappears when I unplug the...
I see single wheel replacements at $60 BTW....I'll buy one eventually if I have to but I bet I can fix this thing!
Yeah I gig a lot so I hear you about using a modern replacement. But just for fun I trie epoxy on the spindle and we'll see if it can handle the...
Both of my 1982 cabs have them. Yes, you don't get speaker breakup like a 25 watt Greenback but that's the point. I run my 50 watt DSL through 8...
Upon further review, it's a Homa caster; my other 1982 cab has the revvo's...
Ha! Thanks for missing me! My band has been gigging constantly and my amp hasn't blown up so yes, I've been scarce...
My Revvo caster exploded Fri night! The clip that holds the two halves together must have broke. I gathered up the ball bearings and race, cleaned...
Marshall doesn't make fuses or tubes. This could have happened with a Mesa, Fender, etc. just as easily. You just have to understand that tube...
The guy had smoke; tightening down the OT isn't going to fix that! Ken
The JCM 2000 series DSL's have a few known issues but when they are addressed they are bullet proof. Are the new h models starting to show up more...
You might try taking the power tubes out and try again. Ken
It's a common mistake to wire one or a pair out of phase; if yours sounds great than you did it right! Ken
