Marshall Amps
Pictures and media of Marshall amps and products only.
Media Navigation
Albums
Categories
-
Good morning @candou2, I’ve had mine for almost ten months with zero noise problems. I hope you enjoy the same experience and are happy with it when you finally get your hands on it. Absolutely... -
I just ordered one. Should get it next week. ANY noise problems? Seen a lot PCBs with burns from Fender as well. They must ofhad a contract, these problems were fixable. Power supply for OP amps,... -
@Hebaton That table is just the resistors for design M. They are all fine, but there's also inductor coils needed, plus switchs, jacks etc. The design here is a bit simpler, just as good:... -
Hi, first thsnks a lot for this ! secound, I would like to build the latest version of the M 4. Is yhis the corect parts list ? Does this need a typr of cooling sustem ? Again thanks you so much. -
@neikeel I also saw somewhere that the three disc caps need a little space between them. It’s in the cabinet right now an I ordered a couple.02 old ceramic disc caps to put in it. Once I get them...
Recent Comments
Top Contributors
- Categories:
- 1
- Albums:
- 1,281
- Uploaded Media:
- 9,853
- Embedded Media:
- 5
- Comments:
- 219
- Disk Usage:
- 2.7 GB