DSL100 Footswitch Neutrik Connection??..

barber · 09-10-2009, 07:32 AM

Hey Everyone,

I have a DSL100 which I've mounted the footswitch to my pedalboard and soldered the line to a Neutrik 1/4" locking jack, which is mounted on the board. I then took a Whirlwind EMC standard balanced mic cable and wired that to a 1/4" jack to make the connection from the Neutrik jack at the board and the DSL head...this works fine regarding switching the channels, however my problem is the LED is extremely dim and I was hoping someone would have some suggestions as to why this is. Any input on how to get the LED back to it's original brightness and still keeping the connection method as I now have it?

Thanks all

09-10-2009, 07:32 AM	#1 (permalink)
barber Junior Member Join Date: Sep 2009 Location: USA Posts: 1	DSL100 Footswitch Neutrik Connection??.. Hey Everyone, I have a DSL100 which I've mounted the footswitch to my pedalboard and soldered the line to a Neutrik 1/4" locking jack, which is mounted on the board. I then took a Whirlwind EMC standard balanced mic cable and wired that to a 1/4" jack to make the connection from the Neutrik jack at the board and the DSL head...this works fine regarding switching the channels, however my problem is the LED is extremely dim and I was hoping someone would have some suggestions as to why this is. Any input on how to get the LED back to it's original brightness and still keeping the connection method as I now have it? Thanks all

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Today
Marshall Amps	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Marshall Amp Forum