Separate names with a comma.
LOL, if I were busy enough playing guitar loud and proud, I probably wouldn't have put the time into building the attenuator either! But in my...
Nik, I'm basically blind without glasses, long-sighted, so that when my glasses move on my face everything goes in and out of focus all the time!...
I think I've figured out what's going wrong, so here's another attempt at just posting the easier to access SoundCloud version of the BassBreaker...
go figure -- the SoundCloud link failed again :) For the moment, if you have access, please try this link to my DropBox account:...
It's really bizarre. I started a thread on TDPRI and my first two audio samples worked perfectly well with links to SoundCloudm and the others I...
And just as an interesting comparison, I recorded a similar very simple riff through my BassBreaker 15 amp using -7db of attenuation on the medium...
Well, sorry for the delay in finally getting back to the earlier question of how the master volume and drive channels worked out on the Hot Rod...
Jordan, you're right about the speaker output levels and the effect this can have on the perceived tone. That's exactly why I generally enjoy...
@Jordan Prysmiki Very nice looking work there. I wish I could get my wiring dressed as tidily as that! I've had a little time to try out the...
I can attest that with my 60W Fender amp, I am very happy that I went against my initial idea and installed the -3.5db stage which really does...
Turn the heat up!
So as guided, I tested the impedance as seen by the amp. Using my 1x12 WGS 16 ohm ET65 I was showing 14 ohm with bypass which surprised me a...
Thanks John. I'll do that as soon as I can and hopefully the measurements will confirm that the unit is really functioning correctly. I have to...
Just finished the attenuator build and, holy firkin crap, it seems to work like a dream :) Many, many thanks to @JohnH for everything you've done...
@tmingle Sounds really close, as JohnH said. I can hear a very slight high end roll off at maximum attenuation. Good job. Now there's no excuse to...
Thanks John. I would have actually started but then my phone beeped with a news alert -- Theresa May's resignation... I think we need a political...
So I'm finally ready to solder! Thing is I have two choices of wire. The first is single core 1.5mm2 (different online sources indicate that this...
Deleted as superseded by earlier edit :)
Sounds great @JohnH. If it works out I might have to change my schematic and layout diagrams yet again!!! I'm using an aluminium enclosure with...
Thanks so much, @JohnH. That's what I thought after your discussion of the jack sockets themselves, but I prefer to get it right the first time...
