Separate names with a comma.
Do you know what is the diameter thread bushing measurements for the Treble and DI Output pots? Is it 9.5 as described by this vendor?...
i have a 1989 JCM 800 2205 with a broken DI output and treble potentiometer which i am planning to replace. The preamp tuve sockets feel a Little...
then why am i having a high pitch squeal when dialing the gain over 8?? I have replaced V1 with 3 different JJ ECC83s and still the same squeal.
Will tightening or replacing the preamp tube socket eliminate this high pitch squeal produced from 8 to 10?
Can you recommend a high gain ecc83 preamp tube brand and model for v1?
i also have a JCM 800 2205 which is producing a high pitch squeal if i dial the gain pot from 7.5 to 10? What could be the cause?
Recently plugged my les paul traditional into my second hand JCM 800 2205 made in 1989 and seem to be getting a high pitch squeal whenever i set...
Just bought a nice 20th anniversary Vibro King. Any opinions? Nice amp but breaks too early with les paul, es 335 and sg 61 reissue. It comes with...
How much deoxit d5 should be sprayed? This is supposed to be a high quality tube amp. Im saving for an attenuator as it is a Non Master Volume amp...
would you recommend JJ 12ax7 or sovtek 12ax7b for this high gain combo amp?
well i changed V7 preamp tube which is the first stage preamp. i will buy a magnifying glass and check all connections once again.
My 1990 red knob twin produces a 5 seconds siren like sound with some crackle when the amp is warming up during the initial 45 minutes of playing....
