eshy

Hi all quick question before I pull my 1936 apart
Set up is as follows, I run a avt150h head
Run into either a 1922 or a 1936 cabinet (or both if need be)

The 1936 is now only running a single speaker in mono mode ? but 2 speakers in stereo mode,
were as the 1922 runs both speakers in mono and stereo Im sure the 1936 is at fault, just wondered what yo look for inside (some sort of switch?)

cheers in advance

Marshall Amps

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Marshall Amp Forum

shentefac

Wow..nice and interesting. i will try it later. Thanks for sharing information. Thanks for the comment, are you talking about the whole designing or a part of? Not bad. Have you done this type of stuff often? It seems like it. i like the idea but how do members of the public remove there details. stainless steel pipe

JohnH

At least the spam post gave your thread a bump...

Whne you are inside the 1936, unless you see something obvious like a wire come disconnected, Id be inclined to test each speaker seperately - just pull off one clip from one of its wires and test Ohms with a multimeter, or touch a 1.5v battery accross its terminals to hear a thump. Once the spaekers are proven, you can investigate the wiring of he switch, and if its not clear, you could always just hard wire the speakers directly to the jack for a reliable and simple mono set up.

__________________
DSL401
8412 cab
Crate Powerblock
1 x 12 Vintage 30 cab
'76 Shergold Masquerader
'93 Les Paul Studio
'83 Roadstar