Quote:
Originally Posted by MartyStrat54
Joe, I found that info about RFT EL34's and it turned out to be on the forum. However, while it did scare me for a moment, I read the rest of the thread and the real truth was posted by a reputable person.
You have to be very careful using a variac because of those heater voltages, I would highly recommend using a separate filament transformer that is run off the 120V line. You don't want to change the filament supply by more than 10% either way so if you have anywhere between 5.7V and 6.9V you should be alright but if you are out of this range you will drastically reduce the life of your tubes and most likely your tone will suffer. Those RFT's should be able to handle 500V on the plate no problem, the EL34 is rated at 800V on the plate, while alot of new tubes can't really handle this the older ones will and I've had good luck with the new production JJ's which I have run at over 600V without any problems. The problem with going to high on the voltage is not that the tube is run harder its that it will internally short between elements due to the high positive potential. As long as your bias is set correctly a tube run at 500V won't be worked any harder than one at 400V.
-Matt at Triodeelectronics.com
So the bottom line is what I have previously posted and that is a NOS EL34 can handle 800 volts on the plate.
Marty
|
Cool. Thanks for the info. I just woke up. You guys have been busy here.
I pm'd back where I had seen that said about the RFT's. Just wasn't any info to why? Looks like the RFT's are within range of actually buying compared to some of those others...when buying at online dealers. I would do it once on the RFT's just to see. The others are out of my buying zone hehe.
And thanks for the great deals man. I saw that price on the Ratheon BP's and I was like shiat! Some of the other tubes I bought too. I wouldn't have tried them out at those prices. Just would have taken a pass.