tgifntx

Here's what it states in the manual,
WARNING:
Always provide the AVT50H with a load
equal to, or greater than, 4 Ohms. Using the
two loudspeaker outputs, with cabinets rated at
8 Ohms each, the full 50W of the specially
designed AVT power amplifier will be
unleashed.

What I've done is, Using only one of the avt50h speaker outs
going into an 4x12 cab rated at max input 280W RMS/16 Ohms.
Am I in essence choking the amp or maybe the amp and cab?
Would I be better off to;
A. Rewire the cab to an 8 Ohm config
B. Rewire the cab to an 8 Ohm config and add an additional
spkr jack out to use both spkr outs, (L&R), so to speak from the avt
50h to "unleash" the avt50h...
I did check the Ohms on both the cab and the avt50h. The cab shows
16 Ohms, (single spkr out) and each of the speaker outs from the head
show 19 Ohms..?
Sorry to bird dog you guys... Just want to make sure I'm not matching
this stuf up all wrong.
Thanks again!

__________________
Epi LP Custom Ltd Edtn/Dimarzio d Activators
Epi LP Stdrd plus top/490r 498t
Epi '65 RI SG G-400 Maestro Custom Shop
Epi SG '66 reissue Custom Shop (Stock)
Epi SG Custom Ltd Edtn/Dimarzio Tone zone/Air norton
Marshall AVT50h/AVT412B
Peavey XXL/XXL4X12
Peavey Classic 50/50
Peavey Classic 30
Boss GT-6
Digitech GSP21L