Marshall Amp Forum - View Single Post

h4r01d · 06-18-2009, 04:38 PM

Hi, I´m new in this forum and I´m writing to see if anybody can help me with a Issue that I get a week ago.
I was playing with my Jcm2000 and suddenly the sound stop, the amp was working but I can't get any sound from the amp. I turned it off and like about 5 minutes I turned it on again to see if it was a problem with the cabinet. The amps starts to working well and then it stop again!. This time I check it the tubes zone and I saw that the first two 12axt went off and the others (plus the tubes on the power amp) were on. So right now, the only way that I can play with my amp is to "heat it" like one hour before I use it, and it works but..... on the run the first 12axt will turn it off and the second one seems to be less iluminated compared to the others two remaining; the amp continues to work but the sound is affected with a lack of volume and overdrive.
I hope anyone out there can help me.... thanks!

06-18-2009, 04:38 PM	#1 (permalink)
h4r01d Junior Member Join Date: Jun 2009 Posts: 3	Trouble with my JCM2000 DSL100 Hi, I´m new in this forum and I´m writing to see if anybody can help me with a Issue that I get a week ago. I was playing with my Jcm2000 and suddenly the sound stop, the amp was working but I can't get any sound from the amp. I turned it off and like about 5 minutes I turned it on again to see if it was a problem with the cabinet. The amps starts to working well and then it stop again!. This time I check it the tubes zone and I saw that the first two 12axt went off and the others (plus the tubes on the power amp) were on. So right now, the only way that I can play with my amp is to "heat it" like one hour before I use it, and it works but..... on the run the first 12axt will turn it off and the second one seems to be less iluminated compared to the others two remaining; the amp continues to work but the sound is affected with a lack of volume and overdrive. I hope anyone out there can help me.... thanks!